Smart Home Community > Tapo Smart Camera > Bad settings in camera
< Tapo Smart Camera

Bad settings in camera

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

Bad settings in camera

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
Bad settings in camera
Bad settings in camera
2025-05-15 03:37:37 - last edited 2025-06-10 06:30:46
Model: Tapo C520WS  
Hardware Version: V1
Firmware Version:

Hi my name is anger. I'm just writing this to let them know that the settings in these cameras are ridiculous because if you get a power outage or Wi-Fi down, you need to factory reset the whole thing again. By pushing the reset button on the back of the camera it should be automatically reconnected in this day and age. This is ridiculous. If I knew this I would not have bought this product

  0      
 
  0      
 
#1
Options
1 Accepted Solution
Re:Bad settings in camera-Solution
2025-05-15 09:26:48 - last edited 2025-06-10 06:30:46

  @Andgar 

Hi,
Usually, the Tapo camera will reconnect to the original Wi-Fi after the router is turned on. If the camera does not reconnect to the original Wi-Fi, please try the following steps.

 

  1. Reboot the router and make sure the Wi-Fi is working.
  2. Disable the Smart Connect function on the router if it has this feature.
  3. Set Different Wi-Fi names for 2.4GHz and 5GHz Bands on the router if possible.
  4. Turn off the camera and turn it back on, then check if it will reconnect to the Wi-Fi.

 

Best Regards

>> Smart Home: Introduction to Common Smart Action Scenarios for Tapo Cameras >> Tapo Camera Day/Night Mode Selection Guide: Best Settings Recommendations for Different Scenarios >> What should I do if my Tapo camera triggers false detection? >> Enhance Your Tapo App Experience: Introduction to Several Practical Features
Recommended Solution
  0  
  0  
#2
Options
1 Reply
Re:Bad settings in camera-Solution
2025-05-15 09:26:48 - last edited 2025-06-10 06:30:46

  @Andgar 

Hi,
Usually, the Tapo camera will reconnect to the original Wi-Fi after the router is turned on. If the camera does not reconnect to the original Wi-Fi, please try the following steps.

 

  1. Reboot the router and make sure the Wi-Fi is working.
  2. Disable the Smart Connect function on the router if it has this feature.
  3. Set Different Wi-Fi names for 2.4GHz and 5GHz Bands on the router if possible.
  4. Turn off the camera and turn it back on, then check if it will reconnect to the Wi-Fi.

 

Best Regards

>> Smart Home: Introduction to Common Smart Action Scenarios for Tapo Cameras >> Tapo Camera Day/Night Mode Selection Guide: Best Settings Recommendations for Different Scenarios >> What should I do if my Tapo camera triggers false detection? >> Enhance Your Tapo App Experience: Introduction to Several Practical Features
Recommended Solution
  0  
  0  
#2
Options

Information

Helpful: 0

Views: 200

Replies: 1

About Us
Press
Copyright © TP-Link Systems Inc. All rights reserved.