Can't connect to camera
This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
Even after resetting camera led just blinks red. Doesn't flash green.
Can't add camera on app so not working at all.
- Copy Link
- Subscribe
- Bookmark
- Report Inappropriate Content
Hi,
You can try the following tips for the reported case.
1. Ensure the camera battery is fully charged. If not, power on the camera with the original power adapter.
2. Press the power button for three seconds to power off the camera, and then press it again to power it back on.
3. Press the reset button on the camera for 10 seconds to perform a factory reset, and then check if the LED changes.
If the LED does not respond to the reset operation, you can try to contact your retailer or our local team to check if the camera is under warranty.
Best Regards
- Copy Link
- Report Inappropriate Content
Hi,
You can try the following tips for the reported case.
1. Ensure the camera battery is fully charged. If not, power on the camera with the original power adapter.
2. Press the power button for three seconds to power off the camera, and then press it again to power it back on.
3. Press the reset button on the camera for 10 seconds to perform a factory reset, and then check if the LED changes.
If the LED does not respond to the reset operation, you can try to contact your retailer or our local team to check if the camera is under warranty.
Best Regards
- Copy Link
- Report Inappropriate Content
Information
Helpful: 0
Views: 187
Replies: 1
Voters 0
No one has voted for it yet.