Smart Home Community > Tapo Smart Camera > Feature Suggestion – Ethernet to Wi-Fi Hotspot Mode for Tapo C310 Camera
< Tapo Smart Camera

Feature Suggestion – Ethernet to Wi-Fi Hotspot Mode for Tapo C310 Camera

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

Feature Suggestion – Ethernet to Wi-Fi Hotspot Mode for Tapo C310 Camera

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
Feature Suggestion – Ethernet to Wi-Fi Hotspot Mode for Tapo C310 Camera
Feature Suggestion – Ethernet to Wi-Fi Hotspot Mode for Tapo C310 Camera
2025-07-10 13:19:12 - last edited 2025-08-07 01:39:46
Model: Tapo C310  
Hardware Version:
Firmware Version:

Dear TP-Link Team,

 

I'm a long-time user of your Tapo C310 cameras. Since these devices already broadcast a Wi-Fi network during setup, I believe it should be technically possible for them to act as Wi-Fi hotspots or access points when connected via Ethernet.

 

This feature would greatly improve flexibility and usefulness, especially in cases where Ethernet is available but Wi-Fi coverage is needed in that area.

 

I strongly encourage you to consider implementing this as a firmware update.

 

Best regards.

  0      
 
  0      
 
#1
Options
1 Accepted Solution
Re:Feature Suggestion – Ethernet to Wi-Fi Hotspot Mode for Tapo C310 Camera-Solution
2025-07-11 06:52:03 - last edited 2025-08-07 01:39:46

  @Redirom 

Hi,
The default Wi-Fi network from the Tapo camera is used for setup, and it will disappear after the camera is configured successfully. The cameras and access points are completely different types of network products. I appreciate your feedback on our product features; however, there are currently no plans to add the reported feature to our cameras.
Best Regards

>> Smart Home: Introduction to Common Smart Action Scenarios for Tapo Cameras >> Tapo Camera Day/Night Mode Selection Guide: Best Settings Recommendations for Different Scenarios >> Enhance Your Tapo App Experience: Introduction to Several Practical Features >> Troubleshooting for Tapo Camera's Privacy Mode Automatic Activation
Recommended Solution
  0  
  0  
#2
Options
1 Reply
Re:Feature Suggestion – Ethernet to Wi-Fi Hotspot Mode for Tapo C310 Camera-Solution
2025-07-11 06:52:03 - last edited 2025-08-07 01:39:46

  @Redirom 

Hi,
The default Wi-Fi network from the Tapo camera is used for setup, and it will disappear after the camera is configured successfully. The cameras and access points are completely different types of network products. I appreciate your feedback on our product features; however, there are currently no plans to add the reported feature to our cameras.
Best Regards

>> Smart Home: Introduction to Common Smart Action Scenarios for Tapo Cameras >> Tapo Camera Day/Night Mode Selection Guide: Best Settings Recommendations for Different Scenarios >> Enhance Your Tapo App Experience: Introduction to Several Practical Features >> Troubleshooting for Tapo Camera's Privacy Mode Automatic Activation
Recommended Solution
  0  
  0  
#2
Options

Information

Helpful: 0

Views: 343

Replies: 1

About Us
Press
Copyright © TP-Link Systems Inc. All rights reserved.