TC40 No Power after failed firmware update
My TC40 does not power on after i unplugged it while blinking green and plugging it back on. Tried several cords and reset it with the button and removing the sd card
- Copy Link
- Subscribe
- Bookmark
- Report Inappropriate Content
Hi,
You can try the following steps:
1. Power on the camera with the original power adapter and cord that comes with it in the box.
2. Ensure the SD card is removed from the camera. Press and hold the reset button on the camera for 10 seconds to perform a factory reset.
3. Try a different power outlet if possible.
4. If the same phenomenon persists, contact your retailer or our local team to check if the camera is under warranty.
Best Regards
- Copy Link
- Report Inappropriate Content
Hi,
You can try the following steps:
1. Power on the camera with the original power adapter and cord that comes with it in the box.
2. Ensure the SD card is removed from the camera. Press and hold the reset button on the camera for 10 seconds to perform a factory reset.
3. Try a different power outlet if possible.
4. If the same phenomenon persists, contact your retailer or our local team to check if the camera is under warranty.
Best Regards
- Copy Link
- Report Inappropriate Content
Information
Helpful: 0
Views: 217
Replies: 1
Voters 0
No one has voted for it yet.