Smart Home Community > Tapo Smart Hub > Two H100 to extend/improve the signal
< Tapo Smart Hub

Two H100 to extend/improve the signal

Two H100 to extend/improve the signal

Two H100 to extend/improve the signal
Two H100 to extend/improve the signal
a week ago
Tags: #Device Connectivity
Model: Tapo H100  
Hardware Version: V1
Firmware Version: 1.5.23

I use a h100 to connect a T100 with a P100 with the smart skill "night light".

Good WiFi signal is ensured with repeaters but I seem to have issues with the sub-G signal. The P100 looses the connection after some time. Can 1 use two H100 to ensure sensor and power plug have a good Sub-G signal? Distance between both seems to be too high.

  0      
 
  0      
 
#1
Options
2 Reply
Re:Two H100 to extend/improve the signal
Thursday

  @MarcSc 

 

The smart plug Tapo P100 is connected to router wifi, not the Tapo hub. When the automation rule did not run as expected, it is important to check the signal strength of all the involved devices, including their control hub. In your case, there are three sections:

1. Sensor to the hub (Tapo SubGHz).

2. Hub to the router (2.4GHz WiFi).

3. Plug to router (2.4GHz WiFi).

 

For more troubleshooting suggestions, check this article: What To Do If Tapo Smart Action (Automation/Shortcut) Doesn't Take Effect or Delay?

▶ Tapo P110M Matter 1.3 Release Energy Monitoring through Matter ▶ Smart HomeBase Tapo H500 - Even More Powerful Smart Hub ▶ First Smart Switch Module! Tapo S112 Smart Switch Module with Roller and Switch Dual Modes ▶ Tapo Camera Image Style & Image Brightness Try out a different image style for your camera!
  0  
  0  
#2
Options
Re:Two H100 to extend/improve the signal
Friday

  @Wayne-TP thanks for your response.

Ok I moved the position of the P110 with a extension cord a bit above the water tank. Seem the water tank blocked the signal too much even it was close to the repeater. Now after setting up the P110 new it has a signal of -51 (RSSI) which at least is working. I will move the repeater or P110 to improve the signal further. 

 

The T100 has still a weak signal of -84 (RSSI). Means I should move the hub h100 closer to the T100, correct? WLAN signal would be no issue there. By moving the h100 closer to the T100 I would increase the distance to the P110 which from your description would have no negative impact, correct?

  0  
  0  
#3
Options

Information

Helpful: 0

Views: 80

Replies: 2

Tags

Device Connectivity
About Us
Press
Copyright © TP-Link Systems Inc. All rights reserved.