Smart Home Community > Tapo Smart Camera > Camera not centralising after detection
< Tapo Smart Camera

Camera not centralising after detection

Camera not centralising after detection

Camera not centralising after detection
Camera not centralising after detection
2025-11-05 15:17:44 - last edited 2025-11-20 03:41:58
Model: Tapo C560WS  
Hardware Version: V1
Firmware Version: 1.0.14

After the camera has detected someone, it doesn't always go back to the original position, especially at night. I have reduced the sensitivity to 4 and run the pan and tilt correction. Any ideas what could be wrong?

  0      
 
  0      
 
#1
Options
1 Accepted Solution
Re:Camera not centralising after detection -Solution
2025-11-06 11:57:03 - last edited 2025-11-20 03:41:58

  @Paul14 

Hi,
You can refer to Q8 in the following instructions for troubleshooting.
General questions about the TP-Link camera's Pan & Tilt feature
Best Regards

>> What to do if the Detection feature is not working on the TP-Link Camera. >> Enhance Video Clarity: Troubleshooting Tips for Improving Camera Video Quality. >> General questions about the TP-Link camera's Pan & Tilt feature.
Recommended Solution
  0  
  0  
#2
Options
1 Reply
Re:Camera not centralising after detection -Solution
2025-11-06 11:57:03 - last edited 2025-11-20 03:41:58

  @Paul14 

Hi,
You can refer to Q8 in the following instructions for troubleshooting.
General questions about the TP-Link camera's Pan & Tilt feature
Best Regards

>> What to do if the Detection feature is not working on the TP-Link Camera. >> Enhance Video Clarity: Troubleshooting Tips for Improving Camera Video Quality. >> General questions about the TP-Link camera's Pan & Tilt feature.
Recommended Solution
  0  
  0  
#2
Options

Information

Helpful: 0

Views: 95

Replies: 1

About Us
Press
Copyright © TP-Link Systems Inc. All rights reserved.