Hi,
I bought a set of two Tapo C120. One of them was fine and I was able to set it up. The other one is continuously fast blinking red light. I have tried to reset it, but i am unable to. Are there any other steps i can take to fix this?
Thank You!
Hi,
You can try the following steps and see if they help.
1. Turn off your camera, and remove the SD card from it if there is one. Turn the camera back on with the original power adapter and cord.
2. Wait for two minutes, press and hold the reset button on the camera for 10 seconds to perform a factory reset. Then, check the LED status on the camera.
3. If the LED is flashing red and green, you can try to reconfigure the camera in the Tapo app: How to set up the Tapo camera
4. If the camera's LED does not change and the camera does not respond to the reset operation, you can contact your retailer or the local support team to check if the camera is under warranty.
Best Regards
Helpful: 0
Views: 40
Replies: 1
No one has voted for it yet.
We use cookies and browser activity to improve your experience, personalize content and ads, and analyze how our sites are used. For more details, please read our Privacy Policy.
