@Wayne-TP bonjour, 

Malgres la mises a jour automatique j'ai toujour la version 1.3.3 buid 251215 rel 7453n.

que faire ?

Merci d'anvance

Wayne-TP wrote

This Article Applies To

Tapo C410/TC82/C411/C402/C403 - V2.0, Firmware 1.3.3 Build 251215 Rel.74534n or earlier versions

 

Description

The camera goes offline, or its live feed cuts out, as soon as it is connected to a solar panel. The connection will be restored after disconnecting the solar panel.

 

Solution

This issue will be addressed in the upcoming firmware. 

 

Workaround

Before the official release, a beta version is available for community users. If you want to try it, follow the steps below to apply the beta firmware.

 

How to Apply Beta Firmware

1. Find the Mac address of your Tapo camera: Open the Tapo app and navigate to the camera's Device Settings page > Device Info.

2. Send a private message to @Wayne-TP with this format: 

[Forum ID 856382] + Mac address of your Tapo camera

 

★★For users from the United States, please contact forumsupport.usa@tp-link.com instead.

 

 

Before the Upgrade

(1) Please be sure you have read the Beta Test Agreement before upgrading the Pre-release firmware!
(2) How to update the firmware of the Tapo devices on the Tapo App
(3) Firmware downgrade is not supported. When a new official version is released, updating it will overwrite the beta version.

  @Wayne-TP 

  @Wayne-TP any update on this issue? Just installed 2 new v2 C410 kit and have this issue still.

I requested the beta firmware, but it been almost 2 months since the issue was found ... and still not new official firmware ...