Solution Tapo C410/TC82 V2 Turns Offline or Live Stream Stops When Connected to a Solar Panel
Solution Tapo C410/TC82 V2 Turns Offline or Live Stream Stops When Connected to a Solar Panel
This Article Applies To
Tapo C410/TC82/C411/C402/C403 - V2.0, Firmware 1.3.3 Build 251215 Rel.74534n or earlier versions
Description
The camera goes offline, or its live feed cuts out, as soon as it is connected to a solar panel. The connection will be restored after disconnecting the solar panel.
Solution
Fixed in firmware 1.3.4 Build 260225 Rel.9062n.
*Firmware releases are usually rolled out in stages, so it’s normal if your device, or some of your devices, can’t see the update yet. Please stay patient; availability will expand gradually over the coming weeks.
Workaround
Before the official release, a beta version is available for community users. If you want to try it, follow the steps below to apply the beta firmware.
How to Apply Beta Firmware
1. Find the Mac address of your Tapo camera: Open the Tapo app and navigate to the camera's Device Settings page > Device Info.
2. Send a private message to @Wayne-TP with the following format. For users from the United States, send your request to forumsupport.usa@tp-link.com.
[Forum ID 856382] + Mac address of your Tapo camera
Before the Upgrade
(1) Please be sure you have read the Beta Test Agreement before upgrading the Pre-release firmware!
(2) How to update the firmware of the Tapo devices on the Tapo App
(3) Firmware downgrade is not supported. When a new official version is released, updating it will overwrite the beta version.
- Copy Link
- Subscribe
- Bookmark
- Report Inappropriate Content
Hi,
Same problem here with my c410
Would appreciate if you could push the beta firmware.
Thanks in advance
Florent
- Copy Link
- Report Inappropriate Content
- Copy Link
- Report Inappropriate Content
- Copy Link
- Report Inappropriate Content
- Copy Link
- Report Inappropriate Content
@pumek_ Beta firmware has been sent to your device, you may check it 30 minutes later in the Tapo app and perform the update.
- Copy Link
- Report Inappropriate Content
edstevens wrote
Yes, the release has started. This is the version that includes the fixes for the issue discussed in this thread.
- Copy Link
- Report Inappropriate Content
Hello everyone, the official firmware containing the fixes discussed in this thread has started rolling out (version 1.3.4 Build 260225 Rel.9062n).
Firmware releases are usually rolled out in stages, so it’s normal if your device, or some of your devices, can’t see the update yet. Please stay patient; availability will expand gradually over the coming weeks.
- Copy Link
- Report Inappropriate Content
- Copy Link
- Report Inappropriate Content
If you have questions about the product or are experiencing any issues, please post your feedback directly. Continued posting of empty or off‑topic replies may lead us to consider the account non‑genuine or automated, which could result in its suspension.
- Copy Link
- Report Inappropriate Content
Information
Helpful: 1
Views: 3274
Replies: 19
Voters 1
