C325WD does not use ethernet.
I have a bunch of cameras. They all got configured and they can access wifi. I connected them with an ethernet cable too, but they don't use ethernet... what can I do? I was expecting them to use ethernet. Even when I cut the wifi signal, they won't use ethernet. This is so frustrating after having installed ethernet all over the place...
- Copy Link
- Subscribe
- Bookmark
- Report Inappropriate Content
Hi,
Usually, if the Ethernet connection works, the camera (Tapo C325WB) will disconnect from Wi-Fi and connect to the internet via the Ethernet cable. For the reported phenomenon, please provide the following information for further analysis.
1. Please describe your network diagram. For example: internet cable — wireless router — switches — cameras, etc.
2. If the camera won't go to the internet through an Ethernet connection after connecting to an Ethernet cable, please disconnect the cable from the camera and connect it to a PC/laptop directly, then check if the PC/laptop has internet through the Ethernet cable. If so, what's the IP address on it?
Best Regards
- Copy Link
- Report Inappropriate Content
Hi,
Usually, if the Ethernet connection works, the camera (Tapo C325WB) will disconnect from Wi-Fi and connect to the internet via the Ethernet cable. For the reported phenomenon, please provide the following information for further analysis.
1. Please describe your network diagram. For example: internet cable — wireless router — switches — cameras, etc.
2. If the camera won't go to the internet through an Ethernet connection after connecting to an Ethernet cable, please disconnect the cable from the camera and connect it to a PC/laptop directly, then check if the PC/laptop has internet through the Ethernet cable. If so, what's the IP address on it?
Best Regards
- Copy Link
- Report Inappropriate Content
Information
Helpful: 0
Views: 1
Replies: 0
Voters 0
No one has voted for it yet.