Hi all,

I bought the Tapo P100 last week and today tried to install it.

That all went very smoothly, I connected it to my phone and wanted to use it to switch my screen on and off remotely.

The screen is an Acer H243H.

At that moment I had:

1. Tapo P100 installed and connected completely, I test it from my Android phone and it worked.

2. The screen powered through the P100.

When I told the plug to shut down, the screen shut down, no problem. However, afterwards I heard a distinct "click" coming from the screen every approximately 15 seconds, as if something was turned on and off very quickly. Almost like the sound of a spark, as if the P100 let a pulse through. I waited a few more "clicks" until I was sure it was coming consistently from the screen. After this I unplugged the screen and plugged it in a normal socket. Now there was no clicking anymore.

Is this normal? Did anyone else experience this? Is there something faulty with the plug or the firmware, how can I prevent these clicks?

Thank you for your time!

Kind regards,

Sebastian