Not working TAPO c200 after updating
Not working TAPO c200 after updating
I wanted to put new software on the camera, but it was not updated, and the camera froze. The red indicator and night light are on. Reset does not help. Off-on too. I was using the camera for literally 30 minutes. The program itself does not see it either. What to do in this case?
- Copy Link
- Subscribe
- Bookmark
- Report Inappropriate Content
Hello everyone,
If the Tapo C200 camera got a firmware update failure, make sure you have tried to factory reset the camera with the camera powered on, check camera still responds to a factory reset, or if the camera still broadcasts the Tapo Camera _XXX default SSID, or if the LED flashes amber and green.
If a factory reset does not help, you can refer to the instructions below to troubleshoot.
What to do if my Tapo Camera gets bricked or doesn't respond to a factory reset?
Best Regards
- Copy Link
- Report Inappropriate Content
Information
Helpful: 9
Views: 12011
Replies: 11
Voters 0
No one has voted for it yet.