Green Led is not blinking in new camera

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

Green Led is not blinking in new camera

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

Jain1992

2024-01-30 14:37:47 - last edited 2024-02-07 10:56:17

Posts: 1

Helpful: 0

Solutions: 0

Stories: 0

Registered: 2024-01-30

Green Led is not blinking in new camera

2024-01-30 14:37:47 - last edited 2024-02-07 10:56:17

Tags: #Firmware

Model: Tapo C200

Hardware Version: V1

Firmware Version:

I have purchased new camera and try to connect but as per the second steps after power on red and green Led should blink but green light is not blinking at all. I have reset the device but still not working. Looks like firmware issue please replace the device or resolve the issue.

1 Accepted Solution

Solla-topee

2024-01-31 08:36:02 - last edited 2024-02-07 10:56:17

Posts: 13664

Helpful: 2360

Solutions: 2035

Stories: 8

Registered: 2020-05-19

Re:Green Led is not blinking in new camera-Solution

2024-01-31 08:36:02 - last edited 2024-02-07 10:56:17

@Jain1992

Hi,
Please try the following steps:
1. You can turn off the camera, wait for two minutes, move the camera close to the router, turn it back on, and wait for another two minutes.

2. Refer to the link below to reset the camera to factory default settings, and check if the LED will flash red and green.
How to reset my Tapo camera?

3. If the LED has no change at all, you can contact your retailer or local support to get a replacement if your camera is under warranty.
If the LED is flashing green and red, you can try to install it.
Tapo Smart Camera Unboxing and Configuration Video

Best Regards

>>Landscape Mode - Tapo App for Pad. >>Smart Action 2.0 Explore and meet the next level home automation. >>How to position my TP-Link camera for optimal performance.