S210/S220 Automation Delay
S210/S220 Automation Delay
I have several S210s and S220s. One of the S220s has one switch connected to mains lights, and the other not connected to anything. Instead, I use the switch to trigger an automation to toggle another S220 switch. When using the switch, there's a delay if a couple of seconds (doesn't sound long, but long enough to notice and be annoying).
When using the Tapo app or even Google Home to trigger any of the switches it's immediate.
Given the switches are HAN/Zigbee, I can't use something like Home Assistant to try an alternative automation, and Google Home doesn't have a "toggle" automation, which complicates it as an alternative.
Any ideas or tips to make it faster?
- Copy Link
- Subscribe
- Bookmark
- Report Inappropriate Content
What's the approximate delay time? 1-2 seconds? 3-5 seconds?
Can you check the signal strength of the switch? (App ->Device's Settings ->Device Info, click the signal icon to check the RSSI rate.) If it gets a weak signal, try to move the hub closer to it.
Please also check the signal strength of the hub as well.
| Strong: more than -50 dBm Good to Average: among -70 dBm to-50 dBm Poor: less than -70 dBm
Note: If RSSI is less than -70dBm, the signal is too weak. |
- Copy Link
- Report Inappropriate Content
- Copy Link
- Report Inappropriate Content
Please check if you have added any delay to the automation rules. Which Tapo hub are you using, the H100 or H200?
If it is the H100, a local smart rule should be faster. Can you share some of the automation settings here?
- Copy Link
- Report Inappropriate Content
@Wayne-TP No delay added to the automation, no. Screenshot:
I have the H100 hub.
What is a local automation?
- Copy Link
- Report Inappropriate Content
- Copy Link
- Report Inappropriate Content
What's the approximate delay time? 1-2 seconds? 3-5 seconds?
Can you check the signal strength of the switch? (App ->Device's Settings ->Device Info, click the signal icon to check the RSSI rate.) If it gets a weak signal, try to move the hub closer to it.
Please also check the signal strength of the hub as well.
| Strong: more than -50 dBm Good to Average: among -70 dBm to-50 dBm Poor: less than -70 dBm
Note: If RSSI is less than -70dBm, the signal is too weak. |
- Copy Link
- Report Inappropriate Content
- Copy Link
- Report Inappropriate Content
- Copy Link
- Report Inappropriate Content
- Copy Link
- Report Inappropriate Content
Are you suggesting there is still a 2.5s delay after the "delay shut off"? What if you disable the delay shut off?
- Copy Link
- Report Inappropriate Content
- Copy Link
- Report Inappropriate Content
Let me show your case to the engineering team, perhaps they will have suggestions to improve this reaction speed. You may check your email later for follow up.
- Copy Link
- Report Inappropriate Content
Information
Helpful: 0
Views: 1178
Replies: 15
Voters 0
No one has voted for it yet.