L510 firmware issue
- Copy Link
- Subscribe
- Bookmark
- Report Inappropriate Content
Update
The cause of the problem discussed in this thread has been located will addressed by future firmware updates.
Before the official firmware release, we have prepared a beta version that can help resolve this issue. Check the following solution article to apply the beta firmware.
Solution - Unable to create Presets for Tapo L510 smart bulb
- Copy Link
- Report Inappropriate Content
Do you use My Presets on the device's page or the Brightness Preset on the device's settings? Please share a screenshot or a video of the problem.
What's the version of your Tapo App?
- Copy Link
- Report Inappropriate Content
Hi Wayne
Obviously you use the "brightness preset" in device settings to change the values of the "my presets" on the first page of the device.
This no longer works after the firmware update mentioned above.
You gou into the "brightness preset" in options, change the setting with the slider to your desired setting, back out to the first page. This setting is not displayed in "my presets"
I have also tested this with my partners phone (Pixel 7a) on her L510 bulb. It was working fine saving the presets in the way described. I then did the firmware update on her bulb and tested the ability to set the "my presets" value. It now, no longer saves the value set.
Tapo app ver on bothe devices 3.6.116
Sorry cant share a video.
But hope this helps
regards
- Copy Link
- Report Inappropriate Content
To assist with this case, a specialist will help to follow it up via email. Please check your inbox later and confirm.
- Copy Link
- Report Inappropriate Content
Update
The cause of the problem discussed in this thread has been located will addressed by future firmware updates.
Before the official firmware release, we have prepared a beta version that can help resolve this issue. Check the following solution article to apply the beta firmware.
Solution - Unable to create Presets for Tapo L510 smart bulb
- Copy Link
- Report Inappropriate Content
When will this be released?
- Copy Link
- Report Inappropriate Content
Can you please tell when this will be fixed in an new firmware release. Since this got broken with the last update.
This is not a feature request, but a feature that has been removed by a mistake.
So please tell us when this will be fixed.
- Copy Link
- Report Inappropriate Content
The firmware hasn't been released yet. But a beta version is available. If you would like to try it, send the Mac address of the smart bulb to me via private message.
- Copy Link
- Report Inappropriate Content
Information
Helpful: 0
Views: 260
Replies: 7
Voters 0
No one has voted for it yet.