@JLE Usually just connecting PC with Ethernet cable to Satellite Deco is enough. Try both Ethernet ports and if nothing works, the issue must be with either Ethernet cable or with PC configuration....

@Lukesan Older devices which only run on 2.4GHz sometimes don't handle well dual band and band steering. I run this configuration for almost 2 years, not sure what in firmware 1.6 triggered that...

@Lukesan Lukesan wrote I reconnected and switched on my R7800 router and enabled 2.4GHz and the same SSID and pwd as a matter of test. Disabled the 2.4GHz on the M5. Guess what. All devices, even 2...

@hejo These are the steps that should work for you: 1. Add M4 as Satellite Deco to your Deco mesh. 2. After you see Deco M4 in your Deco mesh, online, power off one of them, bring to where your ISP...

@Parry22 For your home network, it would make sense to keep Virgin SuperHub 3.0 as is. Instead, configure Deco mesh to run in Access Point mode. See How to set up Deco to work in Access Point mode....

@kbal What you described points at issues with password you selected. Often, it is special symbols, blank space, etc. The common troubleshooting technique is to choose simple weak password and see if...