Hi, I have an Omada OC200 v1 controller running Omada SDN Controller V5.15.24.21 with firmware version 1.36.7 Build 20250707 Rel.72474. In the OC200 web interface, I see the message: “A new version...

@Vincent-TP Hello, do you have any information on whether version 5.3.3 is stable? Is there any risk involved? Also, is it necessary to update to version 5.3.2 first and then to 5.3.3? Thank you,...

Hello, I feel like a fool. Didn’t TP-Link make some server-side changes in my case? If not, then the solution is simply replacing the battery in the T100. The app didn’t report a low level,...

@Wayne-TP Hello, it is exactly as you described. After about an hour, when I enter the room, I see the LED on the T100 blink, but the automation does not trigger (in the app log, however, it is...

Hello, I am running into an issue with automation reliability and would appreciate any suggestions. Troubleshooting steps I’ve already tried: Reassigned the T100 to a different HUB. Connected the...

Hi, I’ve been experiencing an issue with automation using the Tapo T100 motion sensor and the P100 plug. My automation is set so that when motion is detected, the plug should turn on. If there is...