@mamarcos Hi I had a test with our router in lab but can't find the same issue. Firmware Build 20220114 You may check: 1. If your router WAN has a public IP? 2. Is there any VPN server setup? 3....

@Mt.Faith May I know the VLAN interface is set up on your Router, or on the switch? If the switch only have VLAN settings, it should not influence the IPv6 and routing; If the switch also have VLAN...

@Pascal Currently we can only use one Omada controller in one subnet. I will report your requirement to the related department. Temporary solution: If possible, use your Router/switch to build a...

@devzer0 LAG Table will not show anything if the switch ports are not connected to another LAG device. Once LAG take effect you will see the member ports. https://www.tp-link.com/en/support/faq/991/...

@Timberock -94dBm is not a good signal strength. Please check if the AP-Client units have a clear sight between them. And the antenna should be "face-to-face". Other factors:...

@crrodriguez The GPON is designed to be like that. You may check the WAN IP address of the tplink router and if that is a public IP, then tplink router cannot go to the management page of the modem.