@Jokie74 You need to set the Input port for the WAN (switch 1 port 1) as Native vlan 254 Add VLAN 254 as tagged on the trunk between the two switches, and then another native untagged vlan 254 on the...

@topcaser I dont have a 2008P in standalone mode to play about with, but you definitely can and should be able to reach the switch management page on all "Admin" set interfaces. This is a...

@topcaser Have you ticked the "Admin" and "Routing" mode on the vlan interface?

@wiub If this is your home network, there isnt really any pressing need to change the default management vlan from id 1 you can still fully secure it from other vlans with ACLs, but its not like...

@topcaser In standalone mode Omada switches do not have a default gateway setting. For the Switch SVI on the management vlan 10 to be able to route its response back to you, you will need to add a...

@res80 I have 5G based internet at home, i had to tune my MTU ont he WAN port of my ER605 down quite a bit to avoid packet fragmentation, after that i no longer had any issues with DHCP on the WAN...