if upnp works but manual port forwarding does not that usually means the forwarding rules are correct but something upstream is blocking or overriding them first thing to check is if your isp gives...

@Hunterg the issue you describe with wake on lan and static dhcp bindings not always working has been reported by other deco users too when the device goes into standby it sometimes drops off the...

if only the power LED stays on and reset doesn’t respond even after holding for 10 seconds that usually means the firmware is corrupted and the device is stuck in boot stage it’s not something you...

since the spare MR6400 works fine with the same SIM, PSU and antenna it really points to the first unit having a hardware fault most likely the LTE/4G modem inside has failed which sadly isn’t...

unfortunately this looks like a hard brick. on the C8 v1 the normal signs of life would be power LED + LAN activity when you connect a cable, and the reset button should always give some response. if...

@Pro-gamer I saw your screenshots and yes you are testing with very high internet speeds. On firmware 1.2.1 you had around 3288/3164 Mbps and on 1.3.1 it shows about 2794/2631 Mbps. That is still...