@Camnomis I don't know about the pfSense in particular, but if the device in place of the pfSense was, for example, a generic Wi-Fi router or a Windows PC with Ethernet port, then you would setup the...

@Lindamay The screenshot below shows the page from the user manual of the MR600 V2. Look for the item RESET.

@angus122 The WAN (Internet) IP address that you can configure in Router Mode becomes obsolete when you switch the router to Access Point Mode. What you need to configure is the LAN IP address of the...

@Hassan-faiz.123 There a few potential options you have. Use another wireless device that allows 7-digit passwords to connect to the router and then change the wireless password. Connect a device via...

@HereturbiesWalt Hi, You should be able to select "NO-IP" and "DynDNS" in the list of DDNS Service Providers. Just use any of these two if you don't want to use TP-Link ID.

@ConfigureRouter If the two "Wi-Fi" LEDs are off, then it means Wi-Fi is currently disabled. Your router should have a button labeled "WPS/Wi-Fi" on the rear side. Push this button for about 3...