@Cawsie It has been expected since in modem mode the VM Hub is just a bridge between the ISP and your router. This should be mentioned in the VM Hub user guide.

@Aravind93 In general you have to connect the etherrnet cable to the blue port of WR940N. If you didn't changed the SSID of WR940N, then look at the bottom sticker - there you should have the default...

@sirrah You can follow this post and see if that helps. Also there's a resource on the Virgin Media Community:...

@edwpat What's the FW version in question and the issue you have ? It is stated in the release notes that you can't downgrade to a previous version of FW once upgraded. You may reset the device to...

@Aveon It's not mandatory as along as WR940N LAN IP address is in the same subnet. In general WR940N LAN IP address should be outside C6 DHCP range, but in the same subnet (192.168.0.254 is fine)....

@Aveon Your LAN IP is fine, just change the WDS method to WDS2 and reboot to test. If it still doesn't work try swapping devices like I suggested to see if the C6 can build the WDS. Use these...