@ScottG07 You should be able to connect a B3600 *in AP mode), which is connected to another satellite BE3600 in mesh according to this article.

@vfrgpz If your ISP provides Parental Controls through its DNSs, then you could set the Cloudflare's DNSs for "Adult Content + Malware (IPv4): 1.1.1.3 and 1.0.0.3" and check if that works for you.

@TSM23 There's a newer FW release on the Indian support portal - Archer C64(US)_V1_1.13.15 Build 240812. Try it and check if there's any improvement. Apart from that, your best bet is to contact your...

@codeman1352 Adding an Easymesh satellites to a Onemesh main router (AX6000) should be done via the WPS method. Use this guide (Method 1) for that, but before you start reset the AXE75 and AX55 to...

@Faishal Apparently, there's no any development since this inquiry has been made - details.

@TSM23 In general, you can't install EU region based FW on a US region based device - most probably you'll get an error message. As per the FW release history the Bandwidth Control feature was...