Hi, I am using this router with a fail-over wan configured, using a 4G usb modem. Everything works fine and the only problem I am facing is the lack of static ipv4 configuration for usb wan. I want to

Can I set up the two Ethernet ports on the controller separately? Like, can each port have its own IP address?

Hello everyone, I have a problem with my policy routing. I have 3 ISPs (WAN, WAN/LAN1, WAN/LAN2). I created a VLAN (123), created a wireless network with this VLAN and routed it through WAN/LAN1. At t

Hi, Is there an Omada wifi access point that supports vlans for the wired ethernet ports ? I have a situation where I have out buildings that cannot be cabled but are in WiFi range, needing CCTV but a

Hello, Please help. 1st Issue; As you can see on the photo the dashboard still shows no internet, But the when I connect to the AP (EAP110) it does have internet connection. 2nd Issue; The maximum spe

Hi, I'm struggling a bit with routing and NAT. I have the following setup. I have no way to alter configurations on Router B or C. However.. PC1 can sucessfully ping WAN IP of Router D and PC2 can suc