So I found the EAP650-Desktop, looked like the perfect solution to a problem I had, 4 port Switch that could be wirelessly up linked, and I could set the 4 Ports to a particular VLAN. Turns out appare

Hi folks, I would like to know if EAP650 Desktop supports repeater mode with other devices - like Mikrotik. My setup is MT router with wifi and I need to extend coverage via EAP650 in repeater mode. t

Note: The switches are actually the SG2008 v4.20 I am experiencing what I perceive as a multicast problem on one of my VLANs. The setup for the VLAN is very simple as shown below: In this configuratio

This Article Applies To: EAP610 V3 Fully Adapted to Omada SDN Controller v6.1 or above; EAP610 V4 Fully Adapted to Omada SDN Controller v6.1 or above; EAP613 V1 Fully Adapted to Omada SDN Controller v

I have begun to use switch port labels for grouping ports. I have run into the same issue that I mentioned in a post a week ago in which I receive the message "Some tagged networks configured for the

I just finished setting up a separate management VLAN (10) for the controller, switches, and APs. In the devices list, the gateway is still displayed with its default address (192.168.0.1) but the res