The EAP725-Wall for Australia comes in a box label "EU/1.20" but inside the box the device claims it is "AU v1.0" and firmware version 1.1.3. Then if you upgrade the firmware to the latest available 1

Hello. Today, the IPv6 support is missing a lot of features : - There are no way to see the IPv6 routes (the Insights->Routing Table page on the controller only shows IPv4 ones) (high priority) - Ther

What is the colour-coding for A/B for Omada WDM fiber SFP modules? For SM5110 modules "A" is BLUE, but for SM321 "B" is BLUE! That's confusing. Could the WDM product all use the same A/B colour-coding

Inserting a DDM-capable SFP/SFP+ module in an Omada switch adds an enormous 9% load to Omada switch CPUs. Every module adds ~9%! So two DDM modules add ~18% and so on. This seems an unreasonable overh

-The ER7206 needs IPV6 functionality for Wire Guard and DDNS. -Starlink uses CGNAT for their IPV4 addresses. -Therefore, I cannot obtain a public IPV4 IP from Starlink unless I upgrade the service and

When you "Global View" -> "Network Tools" -> "Packet Capture" and the "Sources" is a whole "Site", what traffic or interfaces are being captured?