I had an issue with my old controller which was running 5.12. It kept crashing and whenever I tried to update I kept getting errors. I decided to take a backup and start over with a fresh install of t

Background: This post provides a configuration guide to set up QoS on Omada Switch for Dante and voice-related protocols. This Article Applies to: Omada switches with the QoS feature. L2+ and L3 Switc

I see several feature requests relating to WPA3, but none that appear to address this particular issue. I recently replaced an EAP235-Wall Access Point with an EAP615-Wall Access Point to get roaming

I have a system with 5 EAP access points covering a fairly large area. I have two EAP245s, an EAP225, an EAP225-Outdoor, and I once had an EAP235-Wall covering the far end of the space. The wall unit

On-going Pre-release Firmware Trial for Omada Controllers Omada SDN Controller_V6.0.0.19 Pre-Release Firmware (released on 5th Sep, 2025) Closed Pre-release Firmware Trial for Omada Controllers Hardwa

After upgrading my Controller to v5.0.30 everything appeared to be working normally, until a brief power failure at one of my EAP245s caused it to reboot. At this point it appeared in the Devices list