Hi folks, I am planning to extend my Wifi from a single AP to a mesh of APs. Currently I have an EAP245 V1 and an Omada Controller V3.2.10. In order to set up the mesh, I have to add an AP by means of

I am a networking novice. I have set up a number of new EAP225's as standalone. I have downloaded the controller software and also the mobile app. I can see the AP's as pending on both. My Win 10 PC i

Have set this up, how do I know if it’s working?

Hello everyone, I am looking for a switch that allows me to power cycle specific PoE ports, to reset devices connected to those ports. For example: rebooting a PoE camera, or access point, etc. Will t

Hi All I have internet acces from a wireless ISP that is less than reliable, the have an antenna on my water tank then shoot a wirless link down to the house where it hooks into my router, the wireles

Hi, I'm just new to the TL-ER5120 but have a question to the following physical setup: Internet WAN-Interface => TL-ER5120 => LAN-Interface VLAN800 => Layer3-SW => VLAN700-900 (My Layer is just acting