My RE200(1.0.8 Build 20210916) i think V4 version says onemesh is not supported on my current router which is an Archer C64 updated firmware. Does only V5 mesh with the archer? Also how can i extend r

Swithed from T-Mobile to Xfinity for internet (1Gbps plan) when set up I was getting the 1G speeds consistently. Now I notice they only average around low 4XX.XX Mbps down and 1XX.XX up. This was with

I have set up two AX55 as EasyMesh devices in Access Point Mode (with active Ethernet Backhaul) - both running newest fw [1.5.10 Build 20251119 rel.50509(4555) ] The DHCP server on the AX55 master is

Cannot enable remote access

Hello, my X1500 works fine with three nodes and a fibre 300 MB incoming line. I do have an issue with a 10+ yr old Brother BW-2270 printer, (runs only on 2.4 G band) - whereas I have enabled both band

Could you please tell me whether the EasyMesh protocol used in the Archer BE900 and Archer BE800 routers is R1 or R2?