Access Points
The Access Point products are mainly designed to establish a wireless network, and, with multiple working modes, you can also expand your existing wireless network or provide internet access to your wired only devices. In this section you can say hello to other members, ask, answer or discuss technical topics regarding Access Points.
Access Points
This is a generic question for the signal experts out there about ceiling mounted access points. I want to use a ceiling mounted AP at my house, and I narrowed it down to one of the entry level/small
By
Gui_Lima
0Helpful
2Views
Thanks in advance for any assistance anyone can offer. I have a hardwired backhaul network with four access points: TP-Link router (currently wifi off); two EAP-225 Outdoor WAPs and one EAP-110 Outdoo
0Helpful
106Views
When I try to browse to my WAP, it usually times out. The IP Address is 10.1.1.4. I also have a TL-SG105E with an IP Address of 10.1.1.3. I'm able to get to the TL-SG105E just fine. I mention that as
0Helpful
75Views
EDIT: I rebuilt everything from the ground up and it's working fine now. Not sure what was causing it so I won't be able to tell you if you ask. My WAP is connected to a pfSense router. pfSense is con
Multi-SSID Mode
2Helpful
102Views
I have a EAP 650 outdoor access point that is connected through a POE connector to the Starlink via the Starlink poe connector. After set up the access point works fine through the Omada app but then
Access Pomt
By
Andrew1971
· Latest post 3 недель назад
by terziyski
0Helpful
126Views
Hello, I am thinking of getting the OC200 controller and pair it with 3x AX1800 access points. I will have one AP in my office connected to my PoE switch, which should power on the AX1800. However, I
By
Vinnie1234
· Latest post 2024-03-28 19:28:19
by terziyski
0Helpful
71Views
I bought this access point to extend the wireless network into the back of our apartment. I currently have an Archer A7 connected to my modem and a cable running to a switch in the back. The AP is con
0Helpful
134Views
I just purchased a TP-LINK AXE7800 router and TP-LINK TLWA 3001 access point to create a strong network signal so that I can install wifi security cameras around the property. I have a large house wit
By
Vdefeo3315
· Latest post 2024-02-06 00:16:33
by terziyski
3Helpful
233Views
TP Link, does the AX3000 / WA-3001 Access Point automatically isolate SSIDs when in Multi SSID Mode? Is there any way to turn this off? I am not able to communicate between VLANS assigned to different
3Helpful
282Views
I seem to have lost the original manual and I don't know how to access the administrative portal on my AC1200 wifi AP. I suspect it lost its configuration data and is in setup mode. I cannot access it
By
mweiss
· Latest post 2024-01-15 04:44:09
by Elchochi01
1Helpful
283Views