Home Network Community > Deco > Specify connection between Deco X60 nodes
< Deco

Specify connection between Deco X60 nodes

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

Specify connection between Deco X60 nodes

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
Specify connection between Deco X60 nodes
Specify connection between Deco X60 nodes
2021-03-29 20:56:04

I have Deco X60 3 packs. Somehow, both satellite units are connected to the main Deco. So, the farthest one has weaker signal and causes issues to the clients that connected to it. Is there a way I can specify which unit it connects to? I want to force it to connect to the middle unit.

  0      
 
  0      
 
#1
Options
1 Reply
Re:Specify connection between Deco X60 nodes
2021-04-05 21:51:17

@DecoX60 

 

Using the network optimization feature will have the Deco evaluate the Deco and device connections and make changes for the best connection / speed. You can also try and resetting the furthest node (holding reset for 2 seconds), then adding it back to the Deco network to see if it connects to the closest one.

  0  
  0  
#2
Options

Information

Helpful: 0

Views: 492

Replies: 1

About Us
Press
Copyright © TP-Link USA Corporation. All rights reserved.