AX1500 - Odd switch port behavior

AX1500 - Odd switch port behavior
AX1500 - Odd switch port behavior
2021-04-09 19:34:50 - last edited 2021-04-09 20:12:42
Hardware Version: V1
Firmware Version: 1.1.5 Build 20201230 Rel. 40557(5553)

Hi. I bought two AX1500 routers to use in AP mode to replace a couple of older access points in my home. I have cat 6 cable runs to where I connect my APs. When I connect the AX1500 (either of them) to my network I get an amber light, the device is not connecting to my network I've tried both WAN and LAN ports. However, if I place a netgear switch between my network and the AX1500 it connects without issue, the green light comes up and it's all working.  I don't have any over long cable runs and never had this problem with any piece of equipment that I've connected. Has anyone seen this before? I'd like to remove netgear switches.

 

Firmware Version: 1.1.5 Build 20201230 Rel. 40557(5553)

Hardware Version: Archer AX1500 v1.20

 

Thanks 

 

 

 

EDIT: Disregard. I forgot I split out a few vlans on the old setup. reomving that vlan tags corrected the problem.They're not needed anymore.

0
0
#1
Options