Archer AX73 AX5400 loses config after turn off
This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
Dears,
This is the 2nd TP-Link Router I got but with this one I have some troubling issues. When I turn it off or the power goes out, it loses its config. It doesn't even restore to the factory default (the wifi config on the back of the router sticker). It goes to some funny config where the 2.4G wifi SSID is "TP-Link_XXXX", where the XXXX I beleive is some part of the MAC address.
Is there a way to fix this or should I ask for a replacement? How can I be sure that the replacement would not have the same issue?
Best,
Mladen
- Copy Link
- Subscribe
- Bookmark
- Report Inappropriate Content
hello,
The support team solved my issue. Thank you very much. This was an enterprise-grade reaction and resolution.
if anyone else has the same problem, my advise is to post here in the forum.
best,
- Copy Link
- Report Inappropriate Content
Does the issue happen every time, or it happens occasionally? Except for the 2.4G SSID changed to "TP-Link_XXXX", how about the 5G name and other settings saved on the router, are they still remaining unchanged, such as wireless password?
You can try to reset the router to factory defaults, then reconfigure it from scratch to check if the issue persists.
- Copy Link
- Report Inappropriate Content
Thanks for the reply, Kevin!
Here are my answers:
Does the issue happen every time, or it happens occasionally?
> Every time there is a power outage.
Except for the 2.4G SSID changed to "TP-Link_XXXX", how about the 5G name
> Yes, I get the 2.4G and 5G SSIDs, with small difference in the SSID name
and other settings saved on the router, are they still remaining unchanged, such as wireless password?
> No, all is reset to some "strange" default settings. When I plug into the router on an inner LAN port, it asks to set the admin pass, so default settings are enabled. Funny though that the "TP-Link_XXXX" SSIDs have some default wifi pass "12345670"
You can try to reset the router to factory defaults, then reconfigure it from scratch to check if the issue persists.
> Yes, I did this the last couple of times this happened. This is the 4th time I get the issue. By chance I noticed that there was a power outage for like 30 seconds and after the router started it got the 'default' settings.
Best,
Mladen
- Copy Link
- Report Inappropriate Content
We have reported the issue to the support engineers, they will likely reach out to you via email to continue to troubleshoot your issue.
- Copy Link
- Report Inappropriate Content
- Copy Link
- Report Inappropriate Content
hello,
The support team solved my issue. Thank you very much. This was an enterprise-grade reaction and resolution.
if anyone else has the same problem, my advise is to post here in the forum.
best,
- Copy Link
- Report Inappropriate Content
Information
Helpful: 0
Views: 1371
Replies: 5
Voters 0
No one has voted for it yet.