How do you change channels and bandwidth on the W3600?
This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
Hi I've been using the W3600 as an AP, but wanted to try it out as a wireless router. I cant figure out how to change the channels and bandwidth though...was hoping this would a better router to use over at&ts Arris routers. help?
- Copy Link
- Subscribe
- Bookmark
- Report Inappropriate Content
TP-Link firmware doesn't allow for changing channels or bandwidth on any of their mesh systems.
People have been asking for years, so far nothing and I don't think it will change,
- Copy Link
- Report Inappropriate Content
oh lordy...i guess ill put them back to AP if it comes down to it...only reason i got them was to try and get a better signal in my townhouse, but i dont like Arris routere to begin with. Anyways, I didnt pay attention when i got them, but are they sold with the intent of being a router? or access point, or both?
- Copy Link
- Report Inappropriate Content
- Copy Link
- Report Inappropriate Content
Yeah I had it as AP before, switched back to it a bit ago. I'm not sure if i'm configuring everything correctly or not...i read it's best if i have my 2.4ghz and 5ghz bands with the same SSID and password...does that go for the settings on the W3600 as well? Oh and the Deco channels are different from my gateway's channels...can thast cause problems
- Copy Link
- Report Inappropriate Content
Hi, different brands could not be used together to create the Mesh network.
So most of the time, if there is a main router already, it is suggested to turn off the main router’s wireless network and set up Deco as an access point to take over all the wireless connections.
- Copy Link
- Report Inappropriate Content
Information
Helpful: 0
Views: 1878
Replies: 5
Voters 0
No one has voted for it yet.