Help Please! Lan network and Deco M4

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
Help Please! Lan network and Deco M4
Help Please! Lan network and Deco M4
2021-10-20 10:12:31
Model: Deco M4
Hardware Version: V4
Firmware Version: 20200918

I have a LAN network and a Deco system running all linked to the same Virgin hub 3.

My problems are the Wi-Fi network and the Lan network do not see each other, they both work fine but if I want to use my colour printer (Wi-Fi) when my laptop is connected via Cat5 it can only see my B&W laser printer which is hard wired, and if you want to do any data transfer you can only see what’s on the network that you are connected to. All equipment on Wi-Fi great and if you connect to the cat 5 you can see all the devices on that network. Any ideas ???   

0
0
#1
Options
1 Reply
Re:Help Please! Lan network and Deco M4
2021-10-20 11:31:20

@Nigel4 

I think maybe you set up Deco M4 on the wireless router mode and if both the printer and M4 are connected to the same Virgin hub 3,  the printer is on the WAN side of the clients which is connected to Deco.

So you set up M4 under the access point mode.

0
0
#2
Options