Home

Forums

Stories

Knowledge Base

Home Network Community > Wi-Fi Routers > Use Archer C1200 as an Access Point with network SSD attached

< Wi-Fi Routers

Use Archer C1200 as an Access Point with network SSD attached

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

Use Archer C1200 as an Access Point with network SSD attached

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

Smokey1998

2021-12-22 20:26:12 - last edited 2021-12-23 01:09:00

Posts: 2

Helpful: 0

Solutions: 0

Stories: 0

Registered: 2021-12-22

Use Archer C1200 as an Access Point with network SSD attached

2021-12-22 20:26:12 - last edited 2021-12-23 01:09:00

Model: Archer C1200

Hardware Version:

Firmware Version:

I just installed a 2 pack Dec X20 Mesh system which replaced an Archer C1200. Can I use the Archer as an access point in the network? My main goal is to connect an SSD drive via USB to the Archer to use as a shared network drive. I don't even really need it be a wireless AP.

Proposed Setup:

Modem->Main Deco X20->Switch->Slave Deco X20->Archer C1200 w/ SSD

2 Reply

Kevin_Z

2021-12-23 08:23:19

Posts: 21546

Helpful: 5007

Solutions: 2536

Stories: 21

Registered: 2018-12-24

Re:Use Archer C1200 as an Access Point with network SSD attached

2021-12-23 08:23:19

@Smokey1998

Yes, you can use the C1200 as an access point by connecting it to the satellite Deco X20 with an Ethernet cable. You can then enable and access the SSD attached on it as follows:

https://www.tp-link.com/support/faq/1527/

One more note, if there is no need for the wireless network of the C1200, it's suggested to disable both the 2.4G and 5G wireless network on it to avoid wireless interference with the Deco X20.

Nice to Meet You in Our TP-Link Community. Check Out the Latest Posts: Connect TP-Link Archer BE550 to Germany's DS-Lite (Dual Stack Lite) Internet via WAN Archer GE550 - BE9300 Tri-Band Wi-Fi 7 Gaming Router EasyMesh Is Available When Wi-Fi Routers Work in AP Mode as A Controller. Archer AX55V2 Supports WireGuard VPN, EasyMesh Ethernet Backhaul, IoT Network, Speed Limit,and More If you found a post or response helpful, please click Helpful (arrow pointing upward icon). If you are the author of a topic, remember to mark a helpful reply as the "Recommended Solution" (star icon) so that others can benefit from it.

Smokey1998

LV1

2021-12-23 15:05:14

Posts: 2

Helpful: 0

Solutions: 0

Stories: 0

Registered: 2021-12-22

Re:Use Archer C1200 as an Access Point with network SSD attached

2021-12-23 15:05:14

@Kevin_Z

Thanks. I see that the recommended file system when setting up an external drive is NFTS or FAT32. Will it work with Apple File System? I am using a MacBook.

Also, the proposed setup was not clear. I intend on connecting the C1200 directly to the switch, not the X20 satellite.

Use Archer C1200 as an Access Point with network SSD attached

Use Archer C1200 as an Access Point with network SSD attached

Information

Voters 0

Tags