Configure AX3000 to support multiple SSID
I'm trying to bridge the connection between two buildings using the following network configuration. The primary building "HOME" feeds the internet connection through a CPE710 in AP mode to another CPE710 in client mode. The network contains two SSID, but if I configure the AX3000 on the "BARN" side to AP mode only the primary SSID of the "HOME" network is presented. This appears to be a limitation of the AX3000 in AP mode.
I can't seem to find the option to configure a WDS bridge on the AX3000. If I change the mode and make it a router, is it possible to pass the two SSID to the other side ("BARN") of the connection? Do I need a different AP on the remote side to make this work right? I originally planned to have another EAP610 on the "BARN" side, however I needed a second port to route the network to the EAP110 so I went with a router instead to try to avoid adding another hub or switch hto the mix. The "BARN" side is inside a metal structure, which is why I have to push the signal back outside with the EAP110.