Assign client to specific Deco

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

Assign client to specific Deco

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
Assign client to specific Deco
Assign client to specific Deco
2023-01-11 15:13:57 - last edited 2023-01-11 15:25:05
Model: Deco X60  
Hardware Version:
Firmware Version: 1.0.13

Hello,

For some reason the PC in the living room connecting to the hallway Deco although the Deco in the living room gives better Wi-Fi and closer.

 

Tried the solutions in older threads:

* Give priority.

* Disable Mesh (turn off the second Deco).

* Check QOS.

* Beamforming - Enabled

* Fast Roaming - Enabled

 

Architecture:

2 X60 Decos.

1 Living Room (where PC at)

1 Hallway.

 

Any ideas?

  0      
  0      
#1
Options
1 Reply
Re:Assign client to specific Deco
2023-01-12 06:12:06

  @SPAZ 

Hi, welcome to the community.

I noticed that you also tried to power off the hallway Deco. So did the PC temporarily connect to the living room Deco, then switch to the hallway Deco again once the hallway Deco is turned on?

A successful connection happens on both sides and if the PC ignores the roaming suggestions to keep connected to the living room Deco or thinks it could perform better on the hallway Deco, it will still decide to follow its own path.

Best regards.

  1  
  1  
#2
Options

Information

Helpful: 0

Views: 372

Replies: 1

Related Articles