Home Network Community > Deco > Firmware Recovery
< Deco

Firmware Recovery

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

Firmware Recovery

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
Firmware Recovery
Firmware Recovery
2023-09-23 23:30:17
Model: Deco X50  
Hardware Version: V1
Firmware Version:

so i have followed the uboot recovery directions for my deco x50 version 1.6 and i cannot get it into recovery. unit unplugged static ip set of 192.168.0.2 as suggested hold reset and then plug x50 in but i cannot get it to do anything except stay on solid yellow light and the firmware recovery page does not open it just times out. Is there a specific way to get this into recovery mode that maybe im missing?

  0      
 
  0      
 
#1
Options
1 Reply
Re:Firmware Recovery
2023-09-26 12:14:27

  @icehawk940 

Hi, Thank you very much for your time and patience.

Did it respond to a hardware reset by holding the reset pinhole for 1s?

Have you tried to swap the power adapter with another Deco X50 and also plug it into another power socket, then try to check again whether it could get into firmware recovery mode?

By the way, do you want to run a firmware recovery because the LED on Deco X50 is solid yellow all the time?

Wait for your reply and best regards.

Deco Monthly Recap- Check What's Currently Going on With Deco Deco X50/X55_V1_1.6.0 Open for Test! Try to leave a Message if urgent help is required.
  0  
  0  
#2
Options

Information

Helpful: 0

Views: 292

Replies: 1

Related Articles
Archer C6 v2 EU firmware recovery
965 0
Password Recovery settings.
832 0
Writing predefined WLAN MAC Address on firmware file (TFTP Recovery)
254 0
WR703N v1 recovery image
358 0
Password recovery SMTP settings not working
8801 0
Password Recovery Email SMTP Setup
1992 0
About Us
Press
Copyright © TP-Link Systems Inc. All rights reserved.