Home Network Community > Deco > XE75 Access Point setup
< Deco

XE75 Access Point setup

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

XE75 Access Point setup

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
XE75 Access Point setup
XE75 Access Point setup
2023-12-13 00:33:00

I've seen differing suggestions in a Reddit discussion regarding setting up Deco mesh in AP mode.  So, is the correct way to set the XE75 up normally in router mode, connect the 3 units then go to the advanced tab and switch to AP mode?  If so, do I have to do it for all 3 or once I do one, the other 2 automatically are put in AP mode?

 

Thanks in advance for your time.

  0      
 
  0      
 
#1
Options
2 Reply
Re:XE75 Access Point setup
2023-12-13 02:02:23

  @Beerlord 

Hi, it is correct and after switching to AP mode, all 3 Deco units will automatically be put into Access point mode.

Best regards.

Deco Monthly Recap- Check What's Currently Going on With Deco Deco X50/X55_V1_1.6.0 Open for Test! Try to leave a Message if urgent help is required.
  0  
  0  
#2
Options
Re:XE75 Access Point setup
2023-12-13 02:22:18
Thanks very much!
  0  
  0  
#3
Options

Information

Helpful: 0

Views: 528

Replies: 2

Related Articles
AX20 Access Point setup
913 0
access point
514 0
Extending off of an existing M5 setup as Access Point
240 0
Access point
314 0
TL-WR1043ND as access point
3979 0
Router and router as access point
978 0
About Us
Press
Copyright © TP-Link Systems Inc. All rights reserved.