Home

Forums

Stories

Knowledge Base

Home Network Community > Deco > DECO X20 - Unpair Satellite Deco from Main Deco and use as another AP from another ISP router

< Deco

DECO X20 - Unpair Satellite Deco from Main Deco and use as another AP from another ISP router

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

DECO X20 - Unpair Satellite Deco from Main Deco and use as another AP from another ISP router

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

jrselisana

2024-03-18 09:58:21 - last edited 2024-03-18 09:59:48

Posts: 2

Helpful: 0

Solutions: 0

Stories: 0

Registered: 2023-03-02

DECO X20 - Unpair Satellite Deco from Main Deco and use as another AP from another ISP router

2024-03-18 09:58:21 - last edited 2024-03-18 09:59:48

Model: Deco X20

Hardware Version: V1

Firmware Version:

Good day,

I have a Deco X20 (3-pack) and would like to inquire if it is possible to unpair one of the satellite deco to the main deco and use it as an AP for another network?

Below is the sample diagram. I tried removing one of the satellite deco in the mobile app and reset the 3rd deco but unfortunately, it still keeps blinking red (which indicates that it is disconnected from the main deco),

I appreciate any help that can be done to achieve this setup. Thank you very much :)

4940c07793644e56b75044f2a72c149e

1 Reply

David-TP

2024-03-19 06:39:57

Posts: 12443

Helpful: 1717

Solutions: 1199

Stories: 9

Registered: 2020-04-14

Re:DECO X20 - Unpair Satellite Deco from Main Deco and use as another AP from another ISP router

2024-03-19 06:39:57

@jrselisana

Hi, Are these two modems in the same location?

Deco X20s in the same package are pre-configured so when one of Deco is set up successfully, the rest units will automatically seek the Mesh connection from the first main Deco unit.

If these two modems are within the WiFi range of Decos, it is suggested to power off other Deco X20s when setting up the 3rd Deco X20 with modem2. Then reset it again by holding the reset pinhole for 1s and wait for it to turn to flashing blue.

Thank you very much and best regards.

▶Check What's Currently Going on With Deco ▶Deco Starts Supporting Changing Wireless Channels! Deco BE85_1.1.1 Supports WireGuard VPN,Channel Selection and Matter Deco BE65_V2_1.1.0 Supports WireGuard VPN, Channel Selection and More ▶Deco APP 3.8.102/3.8.112-Ready for A New Deco Onboarding Experience! Try to leave a Message if urgent help is required.

DECO X20 - Unpair Satellite Deco from Main Deco and use as another AP from another ISP router

DECO X20 - Unpair Satellite Deco from Main Deco and use as another AP from another ISP router

Information

Voters 0

Tags