Web Management Interface

Web Management Interface

Web Management Interface
Web Management Interface
2024-09-29 01:54:30
Model: Deco XE75 Pro  
Hardware Version: V2
Firmware Version: 1.2.11

Hello,

 

I replaced my old AX50 router with a Deco XE75 Pro today, and though the installation went fine initially, I soon came to realize that there is no real web management interface for the Deco XE75 Pro that compares in any way (any way at all) to the web management interface on the AX50.

 

I am very disappointed in the product at this point.

 

The app was sufficient for setting the unit up out of the box, but I am unhappy being stuck with the APP for configuration and management.

 

Are there plans to provide a full management interface for this product family?

 

In addition to the general lack of functionality, I also noted that the web interface is http:// only, no secure https:// access. In this modern age, that is not acceptable.

 

I am looking for a tri band WiFi 6e system that supports a proper Web Management Interface though an https:// local only connection. Preferabally one that can be restricted to local wired LAN access only, not over WiFi, not over the WAN.

 

Thank you.

  2      
  2      
#1
Options
4 Reply
Re:Web Management Interface
2024-09-29 15:29:20

  @greyhair Unfortunately the DECOs seem to be geared towards a simplified setup with minimal tinkering required, but also minimal configurability.  One of the newer Archer models probably continue to have similar control like your AX50.

  1  
  1  
#2
Options
Re:Web Management Interface
2 weeks ago

  @jzchen Thanks for the reply. Sadly, part of the reason I bought the Deco units was the 'spousal acceptance' factor. The AX50 was relegated to the basement because it was ungainly and ugly. It worked, but it really limited coverage to the second floor (from the basement) and outdoors, because of its installed location. Before I commited at all to the Deco units, I installed them, one on a sideboard in the living room and one on a bookshelf on the second floor. The design and overall appearance of the units was acceptable, so at that point I started to configure them. So, acceptable to the spouse, but somewhat of a PITA to me. I run my own local DNS cache in the house, and I also configure fixed IPs for certain devices. The IoT feature of the Deco works well with my Nest stuff, that is cool, but the granularity of control on DHCP configuration leaves a lot to be desired, compared to the AX50. So they work well as APs, but I am underwhelmed by their operation as a router, in comparison to a much older TP-Link product.

 

I think ultimately, to resolve it, I will set up either a wired OpenWRT or OpenSense router, and convert the Deco to AP only mode. The other option would be a port of OpenWRT to the Deco Units. Does TP-Link support installing OpenWRT on the Deco line?

 

Is there any documentation on the Deco units in regards to Guest network vlan tagging to separate the guest network from the primary network? I am hoping that Guest network segregation is supported in AP mode.

 

Doug

 

Another option would be for TP-Link to support an AX series model in a Deco style enclosure. We can hope.

  0  
  0  
#3
Options
Re:Web Management Interface
a week ago

  @greyhair 

Same here.  I have an extensive use of DHCP reservations (30+) for my home.  I didn't think that "upgrading" to the Deco Pro would neuter the web console access.

Unfortunately, I can't bring myself to stand up my old TP-Link router for the sole purpose of handling DHCP Reservations and other functions.  
Hopefully, once I finally get it all done via my mobile device, I won't have to tinker much more after that.  Although reading another recent post about a FW update resetting the entire system...that has me a bit apprehensive about the future.  

Little backstory since you mentioned open source.  I had purchased a trio of the MX4500 (LN1301) that were recently being dumped into the retail market for pennies.  They have support(ish) for DD-WRT and OpenWRT.  I went with DD-WRT and was unsuccessful getting a stable network, let alone one that would handle wireless backhaul and device roaming.
So I found a trio of the XE75 Pro (refurbs) on Amazon for < $300.

While I am (initially) thoroughly impressed with the ease of setup and that I am getting 900mbps (of my 1Gb ISP) to my endpoint from the wireless backhaul is impressive to me, 

...I just wish it had a real web management interface...
sad

  0  
  0  
#4
Options
Re:Web Management Interface
a week ago

  @greyhair 

Oy vey!  I think I just found another "gotcha" of the Deco system.

Can you set DHCP reservations?  "Yes", as long as it's within the current DHCP scope...
So where I have my network setup as 10.0.0.0, and DHCP range is 10.0.0.100-120, I can NOT set reservations below or above the DHCP range.

Seriously??? What the ****???  angry
Anyone from TP-Link in these forums that can confirm this functionality? I'd be more than happy to apologize if I missed something.

  0  
  0  
#5
Options