Home Network CommunityWi-Fi Routers IoT network not showing up in available networks listing
Wi-Fi Routers

IoT network not showing up in available networks listing

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

IoT network not showing up in available networks listing

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
IoT network not showing up in available networks listing
IoT network not showing up in available networks listing
2025-11-10 21:35:42
Model: Archer BE9300  
Hardware Version: V2
Firmware Version: 1.1.1 Build 20250430 rel.23359(5553)

My IoT network is no longer showing up in the available networks listing on my devices.  It had previously been listed and the devices I have assigned to that network are running fine.  I have not changed any router parameters and teh IoT network is enabled (see attached pic)

 

 

 

 

  0      
0
#1
Options
1 Reply
Re:IoT network not showing up in available networks listing
2025-11-14 03:53:47 - last edited 2025-11-14 05:34:23

Hello @harken ,

Welcome to our community.

 

Here are some troubleshooting steps that may help you:


1. Log in to your router's web interface or use the TP-Link Tether App, go to Tools > Wireless Settings, and make sure the IoT network is enabled and not set to hidden.
2. Ensure your client devices (phones, tablets, etc.) have the latest drivers and operating system updates installed.

3. Hard reset and reconfigure the router again.

 

Best Regards.
 

Welcome to Our Community! Get the latest posts: △New Firmware for Archer GE550/GE650 V1 Introduces AI-QoS, EasyMesh IoT Expansion, and More! △New Firmware Releases for Archer BE805 V1/BE450 V1 to Support VPN Merge, New ECO Mode, and More! More posts, please see: △ Get the Ongoing Pre-release Firmware for Wi-Fi Routers Here— Subscribe for Updates! Urgent problems with your Wi-Fi Router, Range Extender, or DSL Modem? Please reach out via private Messages or @Joesph-TP in your new thread directly. Click △ Or ☆Recommended Solution if the post/answer helps.
  0  
0
#2
Options

Information

Helpful: 0

Views: 382

Replies: 1