I installed an X60 v3.2 mesh system in a 3200sf house last year. It had WiFi access control which I wanted. I did not have good outdoor coverage because I have 8" concrete walls so I added 2 X50-Outdoor (V1) units. After installation it upgraded to v1.2.8. My WiFi access control disappeared so I did some searching and found a couple of threads saying it needed to be v1.3 or later. So today I was going to look for a newer firmware but noticed that it had updated to v1.3.1. I expected to see the WiFi access control back, but it wasn't there. I rebooted the whole system and still not there. Is it supposed to be there???? or depending on a newer firmware that will never come for version 1???  Any insight would be appreciated.... beginning to be sorry about my choice.