Home Network Community > Wi-Fi Routers > BE9700 Tri-Band Wi-Fi 7 Router Capped Upload Speeds
< Wi-Fi Routers

BE9700 Tri-Band Wi-Fi 7 Router Capped Upload Speeds

BE9700 Tri-Band Wi-Fi 7 Router Capped Upload Speeds

BE9700 Tri-Band Wi-Fi 7 Router Capped Upload Speeds
BE9700 Tri-Band Wi-Fi 7 Router Capped Upload Speeds
Saturday
Tags: #Ethernet Backhaul
Model: Archer BE9700  
Hardware Version: V1
Firmware Version: 1.0.7 Build 20251027 rel.50074(5553)

I wired up the house for ethernet access and my upload speeds are capping around 163 mbps. I have an AT&T Fiber 1000 account so I should be doing better speed-wise. On my Samsung with WiFi7 I'm able to get 900 down/700 up so I'm guessing it's not a modem problem but a setting in the router. QoS is not enabled so I'm not sure what else might affect speeds. Any suggestions?

  0      
 
  0      
 
#1
Options
2 Reply
Re:BE9700 Tri-Band Wi-Fi 7 Router Capped Upload Speeds
19 hours ago

Hello@Wagz ,

Welcome to our community.

 

Do you mean that when the Samsung is connected to the modem's Wi-Fi, it will get a speed of 900 down/700 up?

 

This is the wireless speed; we still need to check the modem's wired speed.

If you have a wired PC, please replace the BE9700 with the PC and test the wired speed of the same LAN port of the modem.

 

On the router, please enable QoS and set the upload speed to 1000 Mbps for a try.

 

 

Welcome to Our Community！ Check Out the Latest Posts: △New Firmware for Archer BE400 V1 to Support IPv6 VPN, Wake On LAN, and More △New Firmware for Archer BE800 V1 to Support VPN Merge, EasyMesh Guest/IoT Network Extend, and More △Enhanced EasyMesh Support with Extended Guest/IoT/MLO Networking and Advanced Features for BE550 V2 △New Firmware for Archer BE900 V2 to Support Multi-WAN, DoH/DoT, EasyMesh in AP Mode and More If you found the post or response helpful, click Helpful. If an answer solves your problem, click Recommended Solution so that others can benefit from it.
  0  
  0  
#2
Options
Re:BE9700 Tri-Band Wi-Fi 7 Router Capped Upload Speeds
3 hours ago

  @Joseph-TP Thanks for reaching out, I found out after some crack AI questions that TP-Link thought my AT&T gateway was another router and it was messing up the speeds. For future peoples with the same problem, here are the steps I took:

 

1. Access the Gateway Interface

  1. Connect a device (laptop or phone) to your AT&T network.  

  2. Open a web browser and type 192.168.1.254 into the address bar.  

  3. If prompted for a Device Access Code, you can find it on a sticker on the side or back of your AT&T Gateway (it's a 10-digit code).

 

2. Check the Status

  • Go to the Firewall tab.  

  • Click on the IP Passthrough sub-tab.  

  • Look for "Allocation Mode":

    • If it says Off, IP Passthrough is disabled.

    • If it says Passthrough, then it is enabled.

 

  0  
  0  
#3
Options

Information

Helpful: 0

Views: 46

Replies: 2

Tags

Ethernet Backhaul
About Us
Press
Copyright © TP-Link Systems Inc. All rights reserved.