WDS Bridging and Routing at the same time [AC1750]
Is there any possible way to configure WDS bridging and (Static) routing on the C7 at the same time? Normally, I'd have the C7 route through the WAN port, but in t his case that is open. Instead, I just have the WDS bridge.
root router:
- 192.168.1.1 / 255.255.255.0
Archer C7
- WDS Bridge to root router on 2.4Ghz band
- [WAN] unconnected
- [LAN] 192.168.1.254 / 255.255.255.???
- static routing:
- 8.8.8.8/255.255.255.255 => 192.168.1.1
DHCP:
- 192.168.1.193-224/255.255.255.192
- gateway: 192.168.1.254 [C7 LAN IP address]
I tried to connect the WAN port back into the LAN RJ45 port, but the configuration says that the WAN and the LAN have to be on different subnets. Can I accomplish this by dividing the 192.168.1.x address space and using different subnet masks?