Establishing Signal Source Ethernet Backhaul Fails
This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
Three M4R units all linked via hardwire Ethernet to my switch in the basement. Main deco is on the ground floor, one upstairs on second floor links fine with signal source Ethernet. The deco in the basement will not link using signal source Ethernet no matter what I try.
- Copy Link
- Subscribe
- Bookmark
- Report Inappropriate Content
I powered off all the deco units and powered them back on starting with the main and then the remote units. Once I did that, the remote units found the hardwired Ethernet and are connected in that manner. The signal source shows up as Ethernet. You can close this ticket. Thank you for helping me with this.
- Copy Link
- Report Inappropriate Content
This should be the setup if the ground floor has the main Deco:
__Deco (top floor)
/
modem > main Deco > switch >/
\
\__Deco (basement)
If that is the case, it may be the port of the Deco, the Ethernet cable the Deco is using, port on the switch.
I would take the basement Deco to the switch and use a different Ethernet cable on different ports to see if that works, and ports. Another thing to try would be to swap locations of the top floor to see if the issue follows the Deco or stays with the location.
- Copy Link
- Report Inappropriate Content
Yes, correct, that is how I have it setup and wired. This is a recent problem, it was working for months with backhaul to both decos' from the main. Now the basement is on WiFi signal source. I will try your suggestions.
- Copy Link
- Report Inappropriate Content
I powered off all the deco units and powered them back on starting with the main and then the remote units. Once I did that, the remote units found the hardwired Ethernet and are connected in that manner. The signal source shows up as Ethernet. You can close this ticket. Thank you for helping me with this.
- Copy Link
- Report Inappropriate Content
Information
Helpful: 0
Views: 745
Replies: 3
Voters 0
No one has voted for it yet.