Archer C9 V1 not working after attempted firmware reset

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

Archer C9 V1 not working after attempted firmware reset

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
Archer C9 V1 not working after attempted firmware reset
Archer C9 V1 not working after attempted firmware reset
2021-11-13 19:45:16
Model: Archer C9  
Hardware Version: V1
Firmware Version:

Just attempted to update the firmware to the most recent version. After it said it got to 100%, the router went offline.

 

Every 8-10 seconds the USB, opposing arrows, and desktop looking lights come on, but nothing else.

 

I have tried the factory reset multiple times and nothing works.

  0      
  0      
#1
Options
1 Reply
Re:Archer C9 V1 not working after attempted firmware reset
2021-11-16 10:06:33

@agallina 

 

That's bad. How did you upgrade the firmware? Via wired cable between the router and computer or via a wireless connection? Is there any power outage during the update?

 

Try following the firmware recovery procedure to see if you can make it alive again:

https://community.tp-link.com/en/home/stories/detail/582

Nice to Meet You in Our TP-Link Community. Check Out the Latest Posts: Connect TP-Link Archer BE550 to Germany's DS-Lite (Dual Stack Lite) Internet via WAN Archer GE550 - BE9300 Tri-Band Wi-Fi 7 Gaming Router EasyMesh Is Available When Wi-Fi Routers Work in AP Mode as A Controller. Archer AX55V2 Supports WireGuard VPN, EasyMesh Ethernet Backhaul, IoT Network, Speed Limit,and More If you found a post or response helpful, please click Helpful (arrow pointing upward icon). If you are the author of a topic, remember to mark a helpful reply as the "Recommended Solution" (star icon) so that others can benefit from it.
  0  
  0  
#2
Options

Information

Helpful: 0

Views: 702

Replies: 1

Related Articles