Assign signal source for a satellite deco

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

Assign signal source for a satellite deco

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

James912

2022-04-18 22:22:59 - last edited 2022-04-18 22:36:45

Posts: 1

Helpful: 2

Solutions: 0

Stories: 0

Registered: 2022-04-18

Assign signal source for a satellite deco

2022-04-18 22:22:59 - last edited 2022-04-18 22:36:45

Model: Deco S4

Hardware Version: V2

Firmware Version: 1.5.1

I have many deco S4 units, with some locations really needing a satellite -> satellite -> main node topology over wireless, but these satellites seem to strongly prefer the main node's signal, however far away and faint.

Can we get a firmware that lets us control which signal source a satellite should use?

Thanks!

2 Reply

David-TP

2022-04-20 03:14:43

Posts: 12841

Helpful: 1806

Solutions: 1298

Stories: 9

Registered: 2020-04-14

Re:Assign signal source for a satellite deco

2022-04-20 03:14:43

@James912 welcome to the community.

This feature has been accepted and is planned to be added to the later firmware.

Currently, would it be possible for you to have a look at this link first and send an email to support.forum@tp-link.com with the required information in the recommended solution?

So later we could invite the engineers to check for us whether it is necessary to re-select the signal source.

Manual Signal Source Selection on Deco

Thank you.

Best regards.

▶Check What's Currently Going on With Deco ▶Deco Starts Supporting Changing Wireless Channels! ▶KidShield Now Open for Trial! Try to leave a Message if urgent help is required.