Deco M4 Mesh - Main Router has blue pulse after a few hours and all other mesh devices go red
This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
Have installed the Deco M4 at a customer site with 6 mesh access points
Have had no issues up until yesterday when client said they cannot connect to internet and all the other m4 devices were flashing red.
Found main M4 deco connected to NBN Modem was flashing blue
Pressed the reset button to factory default the main Deco M4 and resetup network with new SSID and Password
Added the remaining 5 Deco M4 to the network and all was working OK
5 hours later main deco m4 router has gone back to flashing blue and network is down as it was
All Decos using the same hardware and firmware revision, im going to try and swap the main deco m4, with another one today and make one of the others the main router to see if this fixes the issue.
Also found once i left the site/ wireless network range with my phone i could no longer see the site on the Deco App?
Has any one experienced this?
Thanks
Michael
After making one of the other deco m4's the main router, and resetting up the whole network again its finally stable with no issues.
Why does it show two different firmware versions in the photo below? Why wont the main deco upgrade to the same version as the one below?
